Briquetting of Cassava Peel (Manihot Esculenta) With Styrofoam Adhesive as Alternative Fuel

Authors

  • Afif Thaifuri MTsN 1 Banda Aceh
  • Nurmahni Harahap MTsN 1 Model Banda Aceh

DOI:

https://doi.org/10.63924/jsid.v5i2.64

Keywords:

Briquettes, Cassava peel, Styrofoam, Alternative solid fuels

Abstract

Briquetting technology that uses cassava peels as a base material has the potential to reduce dependence on conventional fuels and maintain environmental sustainability. Cassava peel waste can be used as an alternative solid fuel source. The aim of this research is to explore the process of making briquettes from cassava peels with added styrofoam adhesive, which can be used as an alternative to petroleum and natural gas. The research involved five stages, namely preparation, drying, mixing, burning, and quality testing. The method used was experimentation by testing cassava peel briquettes against the parameters of briquette mass, combustibility, and water heating time. The results showed that the average mass of briquettes after the production process was about 0.16 kg. The fastest burning time is 67 minutes 02 seconds, and the fastest 100 mL water heating time is 1 minute 05 seconds.

References

Abthal, H. (2024). Development of Microsoft Powerpoint Learning Media on Chemical Bonding Material. Journal of Society Innovation and Development (JSID), 5(2), 130-139.

Adnyana, I. W., Dana, I. W., & Kusuma, I. G. (2008). Briket dari Cangkang Kemiri. Seminar Nasional Tahunan Teknik Mesin VII.

Cristina, G. (2024). The Acehnese Folklore and Social Behavior. JOURNAL OF ACEH STUDIES (JOAS), 1(1), 51-60.

Ediy, R. S., & Widyastuti, S. (2013). Kelayakan limbah pabrik gula Blotong sebagai briket Blotong berpori untuk bahan bakar alternatif. Jurnal Teknik WAKTU.

Hendra, D., & Darmawan, S. (2000). Pembuatan Briket Arang Dari Serbuk Gergajian Kayu Dengan Penambahan Tempurung Kelapa. Vol. 18 No. 1, 1-9.

Julius, B. S., & Johannes, H. (1990). Bioarang untuk Memasak. Yogyakarta: Liberty.

Kalsum, U. (2016). Pembuatan Briket Arang Dari Campuran Limbah Tongkol Jagung Kulit Durian Dan Serbuk Gergaji Kayu Menggunakan Perekat Tapioka. Distilasi, Vol. 1 No. 1, 42-50.

M.Oliveira, G., Iskandar, T., & Yuningsih, S. (n.d.). Optimalisasi Proses Pembuatan Briket Arang Dari Jerami Padi Menggunakan Teknologi Slow Pyrolisis. PS.Teknik Kimia,Fakultas Teknik,Universitas Tribhuwana Tunggadewi.

Misbah, T. L. (2019). Intercultural Communication: Acculturation, Assimilation and Problems. Journal of Society Innovation and Development (JSID), 1(1), 16-20.

Mithen, Paloboran, M., & Musa, I. (2017). Pemanfaatan bahan bakar briket biochar dari limbah pertanian pada masyarakat Kecamatan Galesong Selatan Kabupaten Takalari. TEKNOLOGI, 17 NO. 1 .

Munidar, F. (2024). The Acehnese Literature and Social Behavior. JOURNAL OF ACEH STUDIES (JOAS), 1(1), 31-40.

Muzi, I., & Mulasari, S. A. (2014). Perbedaan kandungan lem briket bioarang kosong dan briket biochar tempurung kelapa pada saat perebusan air. Kesmas, Vol.8, No.1, 1-10.

Ningsih, D. R. (2012). Makalah Bioteknologi Peran Dalam Bioremediasi Limbah Plastik Dan Styrofoam. Cirebon.

Paull, J. (2024). The Impact of Coffee Shops on Aceh's Economic Sustainability. JOURNAL OF ACEH STUDIES (JOAS), 1(1), 41-50.

Rahmadani, A. (2024). The Writing Culture of Scholars of The Aceh kingdom. JOURNAL OF ACEH STUDIES (JOAS), 1(1), 9-20.

Rismayani, S., & Tayibnapis, A. S. (2011). Produksi biobriket dari limbah sabut kelapa dan abu dasar. Balai Besar Tekstil.

Rudi, D. A., Wijaya, T. S. I., & Murdani, T. (2021). Socio-Economic Correlation of Scavenger Community in Religious Life. Journal of Society Innovation and Development (JSID), 3(1), 16-20.

Sinurat, E. (2011). Kajian Pemanfaatan Briket Kulit Mete dan Tongkol Jagung Sebagai Bahan Bakar Alternatif. Fakultas Teknik. Universitas Hasanuddin. Makassar.

Sirajuddin, Z. (2021). Pengaruh kepadatan bahan terhadap kualitas briket arang tempurung kelapa. Jurnal Ilmu-ilmu Pertanian, 26-37.

Sulistyaningkarti, L., & Utami, B. (2011). Briket dari Arang Limbah Organik Tongkol Jagung. Jurnal Kimia Dan Pendidikan Kimia, Vol. 2 No. 1, 43-53.

Tiara, A. (2022). Society: Solutions for Building Ethics Communication on Social Media. Journal of Society Innovation and Development (JSID), 3(2), 013-017.

Wirahadi, M. (2017). Elemen internal dari busa polistiren dan pengolahan limbah kulit jeruk. Jurnal Intra, Vol. 5, No. 2, 144-153.

Zikrullah, M. (2023). GIS Implementation to Create a Map for Waste Container Sites in Banda Aceh, Indonesia. Journal of Society Innovation and Development (JSID), 4(2), 0011-00144.

Downloads

Published

2024-05-05

How to Cite

Afif Thaifuri, & Nurmahni Harahap. (2024). Briquetting of Cassava Peel (Manihot Esculenta) With Styrofoam Adhesive as Alternative Fuel. Journal of Society Innovation and Development, 5(2), 165–173. https://doi.org/10.63924/jsid.v5i2.64

Issue

Vol. 5 No. 2 (2024): Journal of Society Innovation and Development

Section

Articles

License

Copyright (c) 2023 Afif Thaifuri

Creative Commons License

This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.

Most read articles by the same author(s)

1 2 > >>